Clips and fasteners come in a variety of styles and sizes. When you
specify a specific style of clip or fastener, the quote you receive
will include the exact clip size appropriate for your grating.
Note: Steel fasteners used on aluminum or galvanized steel gratings
must be galvanized.
Notching bearing bars to adjust the grating so that it is flush
with the elevation is not recommended. Similarly, grating which is
welded to an angle or toe plate and supported by the weld rather
than the bearing bar surface is not recommended and should not be
specified. Best results are obtained by always specifying the
bearing bar height that results in the proper height of the grating
Fiberglass grating clips come in a variety of styles and sizes for
all types of fiberglass gratings. Clips can be used to secure
grating or plate to the supporting structure or fasten adjacent
gratings panels to minimize load induced differential deflection.
All clips are made of stainless steel 304, 306 or 316L for maximum
corrosion resistance and are available in 1", 1-1/2" and 2". All
clips are sold as set consisting of clip, bolt, nut and washers.
There are six main clips used to fasten the FRP gratings into
L clip for securing grating to support frames for moderate load.
M clip secures molded or pultruded panels to a support using two
adjacent bearing bars. Recommended for stair treads and most molded
and pultruded fiberglass gratings.
C clip is designed to tie two adjacent panels of molded FRP gratings
J clip for holding one fiberglass grating load bar to the support
frame using one bearing bar.
G clip attaches grating to any structural member flange. It fastens
grating to horizontal-facing steel structure.
F clip provides a simplified method for joining factory edges of
adjacent abutting panels.
Screws and Rivets
Nominal 4 per panel.
Approximately 3 per M2 where span is > 1500mm.
Approximately 5 per M2 where span is > 750mm or less
Fixing Clips are not generally recommended in areas of vibration or
where lateral loads are applied to the grating.
Welding grating to the support structure is a suitable method of
fixing, provided minimum requirement are met. The minimum number of
welds is four per panel.
Weld 5mm fillet 25mm long at 1000mm centres.
Expanded Mesh:Weld every fourth strand.