Remote Controllable , Microwave Motion Sensor Switch , Enhanced
Round shape, naked board, specially designed for highbay
fixtures(warehouse lamp / canopy / shoebox / gas station lamp /
stadium lamp, etc), totally integrated onto the board, 100%
built-in. Reinforced detection range up to 12~15m high, using
infrared remote control to change all the settings. No need to use
a BIG & HEAVY & EXPENSIVE stand alone IP65 sensor any
more!!! Perfect substitution help you to save utmostly!
5.8GHz C-band microwave.
Input voltage 12V DC (5V / 24V DC version available on request).
0~10V dimming signal. (5V DC high-low voltage & PWM output
version available on request)
Super compact(∅40mm only), easily built into all kinds of highbay
Dual-processor technology, real Lux -Off & Daylight monitoring
function for built-in application.
IR remote commissioning, easy setting and user friendly.
Detection range up to max.18m in diameter.
Mounting height: max. 15m.
Operation temperature: -20℃ ~ +70 ℃
Settings(by remote control IR12)--
Permanent ON/OFF function
Press “ON/OFF” button, fixture goes to permanent on or permanent off mode, sensor
*press "Auto” ,”Reset" or “Ambient learn” to quit this mode.
Press "Dim" button to automatically dim up or down the light
brightness during hold-time from 10% to 100%. Another press to lock
it down when desired brightness is achieved.
*after desired brightness is locked down, if user wants to dim
again reversely, just press the “Dim” button again and then lock down the new brightness again.
Press “Auto” button, the sensor starts to work and all settings remain the same
as the latest status before the light was switched on/off.
Press”Reset” button, all settings go back to factory default settings.
*Factory default settings--
Press "Ambient learn" button, the latest surrounding lux value
overwrites previous lux value learned, and set as the daylight
threshold. This feature enables the fixture to function well in any
real application circumstance.
"Test mode"is for testing purpose only, for users to check the
functionality and choose the desired detection range. The sensor
goes to test mode automatically after pressing this button.
Users can quit this mode by pressing "ON/OFF", "Reset' or any
button of "Hold time". The sensor settings are changed accordingly.
*Test mode defaulted settings—
In this mode, when used for on/off control, after motion detected,
sensor enters into a cycle of 3s on and 2s off. In this mode, when
used for tri-level dimming control, after motion detected, sensor
enters into a cycle of 3s on and 2s off(0.5s soft off + 1.5s off).
Daylight monitoring function--
Utilizing the Dual-processor technology, this sensor can tell the
difference of natural light and artificial light(lamp) from behind
the diffuser, switch on automatically(even without movements) when
the ambient light is below target value, and then switch off
automatically whenever the artificial light is not required
(ambient light is bright enough).
This is the REAL& INTELLIGENT daylight monitoring sensor for
Note: Lux-Off sampling time—30s; Lux-On sampling time—10s.
Lux-On function takes effect only when standby dimming period set